Audi A4 2010 - Page 137

Audi side assist Ill
_______________ ____.
Applie s to vehicles : wi th side assist
Driving situation: Vehicles dropping back
quickly
@
I
- (OIDJ -
•. _ ...
'
I
- Q•n
-~---
Fig. 133 Side assist: Vehicles dropping back quickly
(D Signal on outside mirror does not light up
The vehicle just passed has not yet been detected by side assist. The
signal on the outside mirror does not light up~
& in "Safety tips" on
page 137.
@ Signal on outside mirror does not light up
The vehicle dropping back quickly on the right (difference in speed of
more than 9 mph, or 15 km/h) has been detected by side assist, but
is not considered notable in the event of a lane change, because it is
dropping back so quickly . The signal on the outside mirror does not
light up ~ & in "Safety tips" on page 137.
Cont rols and equip-
ment
Vehicle OP-eration
® Signal on outside mirror does not light up
If you activate your turn signal in driving situation @ , the signal still
does not light up on the outside mirror~
& in "Safety tips" on
page 137. •
Appli es to vehicles : with side assist
Setting the signal brightness on the
outside mirror
The signal brightness con be set in the radio or MM!*.
- Select: Function button [CAR ]> Audi side assist - lamp.
- Rotate the control knob to adjust the displayed brightness
of the signal light on the outside mirrors.
The brightness of the signal light for both the informational and alert
stages is automatically adjusted to ambient light conditions. In addi-
tion, you can adjust the
basic brightness separately, via the bright-
ness funct ion.
While making the adjustment, the new brightness setting is
displayed briefly. The brightness displayed is that of the informa-
tional stage signal. The alert stage signal brightness is linked to the
informational stage signal brightness.
The informat ion al stage signal brightness should be adjusted so that
you notice the signal illumination when you look in the outside
mirror, but not when you look forward through the windshield.
In very dark or light surroundings, the automatic brightness setting
adjusts signal light brightness to maximum or minimum intensity , as
needed. In circumstances such as these, you may not notice any
change in the brightness on the outside mirror when adjusting the
basic brightness.
You may not notice the change until lighting conditions are normal
again.
Vehicle care Do-it-yourselt service iTechnical data