- Pull the mechanical key ® out of the master key.
- Press the release button @ =>
page 38, fig . 27 on the
batte ry holder and at the same time pull the battery
holder out of the master key in the direction of the arrow.
- Install the new battery CR 2032 with the"+" sign facing
down.
- Push the battery holder carefully into the master key.
- Install the mechanical key.
~
For the sake of the environment
Dispose of dead batteries properly so as not to pollute the environ-
ment.
(I] Tips
The replacement battery must be the same specification as the
original. •
Removing the mechanical key
- Press the release button @ => fig. 28.
Cont rols and equip-
ment
Fig. 28 Remote
master key: Removing
the mechanical key
Vehicle OP-eration
Opening and closing
- Pull the mechanical key ® out of the master key.
Using the mechanical key, you can
• Lock and unlock" the storage compartment on the passenger's
side => page 86.
• Lock and unlock the lockable rear seat => page 78.
• Lock and unlock the vehicle manually=> page 44 if this should not
be possible with the master key. •
Emergency unlocking of the ignition key
In the event of malfunctions in the electrical system, it
may happen that you cannot remove the ignition key.
Fig. 29 Ign it ion
switch with ignition
key
If you are unable to remove the ignition key, for example
because the vehicle battery is discharged, proceed as follows:
- Press the release button @ => fig. 29 for example with a
ball point pen and pull the mechanical key ® out of the
master key.
- Lock the vehicle using the mechanical key =>
page 44.
- Have the electrical system inspected by an authorized Audi
dealership. •
Vehicle care Do-it-yourselt service iTechnical data
To Next Page
Loading...
