8. TROUBLESHOOTING
1. bit Nove operating problems
If, when calibrating the system with the bit Nove connected to a laptop there are operating problems, try
disconnecting the laptop power supply cable.
With the laptop working on battery power you avoid a possible voltage difference in the USB ground between
the vehicle (bit Nove) and the ground (PC).
2. Connection lost between bit Nove and the PC
If, while calibrating the system with the PC connected to the bit Nove, the amplifier is turned off and back on again,
the connection is lost and the software cannot finalize the adjustments that were set. To avoid losing the
settings, proceed as follows:
a. Save the setup to a file on the PC using the FILE / SAVE SETUP function.
b. Exit the software.
c. Turn the bit Nove on.
d. Launch the software again.
e. Load the setup file again that was saved using the FILE / LOAD SETUP function.
3. bit Nove does not respond
If calibrating the system with the PC connected to the bit Nove and the latter does not respond to the commands,
proceed as follows:
a. Turn off bit Nove by pressing the knob on the DRC or disconnecting the Remote IN or even disconnecting
the power cable for a second.
b. Save the setup to a file on the PC using the FILE / SAVE SETUP function.
c. Exit the software.
d. Turn the bit Nove on.
e. Launch the software again.
f. Load the setup file again that was saved using the FILE / LOAD SETUP function.
4. Settings not saved
To successfully complete the bit Nove configuration and not lose the work done, remember to store the settings
made. Access the "File" menu from the management software via the PC and choose “Finalize the device”.
8.1 SYNCHRONIZATION WITH A PC
8.2 BACKGROUND NOISE
Loud hissing/background noise.
If there is excessive hissing/background noise, it may be necessary to repeat the setup for the input sensitivity and/or
correct the output level calibration. For more details
see sec. 7.2.
8
To Next Page
Loading...
