By clicking on this item, a drop-down menu appears with the entries
shown in the image:
7.3.5 DEVICE MAIN MENU
1. Synchronize: this function synchronizes the PC with the bit Nove
and vice versa due to communication losses caused by the
device shutting down or for other reasons.
Read from Device: the PC loads the settings present
in the bit Nove memory to the PC Software.
Write to device: the PC loads the current settings
on the bit Nove memory.
3. Update firmware: this allows
firmware updates on bit Nove
(see sec. 8.3.2).
4. Reset factory default: performs full reset of bit Nove
returning the product to its original conditions, deleting all
previously saved data from the processor memory.
2. Finalize the device: it allows you to load all of the parameters set during
system calibration in the internal memory, letting the bit Nove
operate without being connected to the PC.
When Finalize to bit Nove is performed, the software provides a warning
message that the data previously saved in the bit Nove will be overwritten.
- Click on YES to load the data.
- Click on NO to interrupt the procedure.
5
1
2
3
4
7
To Next Page
Loading...
