AUMA SA 07.2 Operation Instructions

336.2.5. Fieldbus cables: connect
346.2.6. Fieldbus terminal compartment: close
356.3. Accessories for electrical connection
356.3.1. Actuator controls on wall bracket
366.3.2. Parking frame
366.3.3. DS intermediate frame for double sealing
376.3.4. External earth connection
387. Operation................................................................................................................................
387.1. Manual operation
387.1.1. Manual valve operation
397.2. Motor operation
397.2.1. Operating the actuator from local controls
407.2.2. Actuator operation from remote
407.3. Menu navigation via push buttons (for settings and indications)
417.3.1. Menu layout and navigation
427.4. User level, password
437.4.1. Password entry
437.4.2. Password change
447.4.3. Timeout for incorrect password entry
447.5. Language in the display
447.5.1. Language change
468. Indications..............................................................................................................................
468.1. Indications during commissioning
468.2. Indications in the display
478.2.1. Feedback signals from actuator and valve
498.2.2. Status indications according to AUMA classification
508.2.3. Status indications according to NAMUR recommendation
518.3. Indication lights of local controls
528.4. Optional indications
528.4.1. Mechanical position indication via indicator mark
539. Signals (output signals).........................................................................................................
539.1. Status signals via output contacts (digital outputs)
539.1.1. Assignment of outputs
539.1.2. Coding the outputs
539.2. Analogue signals (analogue outputs)
5410. Commissioning (basic settings)...........................................................................................
5410.1. Type of seating: set
5510.2. Fieldbus address (slave address), baud rate, parity and monitoring time: set
5510.3. Open switch compartment
5610.4. Torque switching: set
5710.5. Limit switching: set
5710.5.1. End position CLOSED (black section): set
5710.5.2. End position OPEN (white section): set
5810.6. Intermediate positions: set
5810.6.1. Running direction CLOSE (black section): set
5910.6.2. Running direction OPEN (white section): set
5910.7. Test run
5910.7.1. Direction of rotation at mechanical position indicator: check
6010.7.2. Direction of rotation at hollow shaft/stem: check
3
SA 07.2 – SA 16.2/SAR 07.2 – SAR 16.2 Control unit - electromechanical
AC 01.2 Intrusive Modbus RTU Table of contents

AUMA SA 07.2 Specifications

General

Brand	AUMA
Model	SA 07.2
Category	Controller
Language	English