AUMA SA 07.2 - Page 4

6110.7.3. Limit switching: check
6110.7.4. Reference operation position feedback: perform
6110.8. Close switch compartment
6311. Commissioning (optional equipment settings)...................................................................
6311.1. EWG 01.1 electronic position transmitter
6411.1.1. Measuring range: set
6511.1.2. Current values : adjust
6511.1.3. LED end position signalling: switch on/off
6511.2. Potentiometer
6611.2.1. Potentiometer: set
6611.3. RWG electronic position transmitter
6711.3.1. Measuring range: set
6711.4. Mechanical position indicator: set
6912. Corrective action....................................................................................................................
6912.1. Faults during commissioning
6912.2. Fault indications and warning indications
7412.3. Fuses
7412.3.1. Fuses within the actuator controls
7412.3.2. Fuse replacement
7412.3.2.1. Replace fuses F1/F2
7512.3.2.2. Test/replace fuses F3/F4
7512.3.3. Motor protection (thermal monitoring)
7713. Servicing and maintenance...................................................................................................
7713.1. Preventive measures for servicing and safe operation
7813.2. Maintenance
7813.3. Disposal and recycling
7914. Technical data.........................................................................................................................
7914.1. Technical data Multi-turn actuators
8114.2. Technical data Actuator controls
8714.3. Tightening torques for screws
8815. Spare parts.............................................................................................................................
8815.1. Multi-turn actuators SA 07.2 – SA 16.2/SAR 07.2 – SAR 16.2
9015.2. AC 01.2 actuator controls with SD electrical connection
92Index........................................................................................................................................
4
SA 07.2 – SA 16.2/SAR 07.2 – SAR 16.2 Control unit - electromechanical
Table of contents AC 01.2 Intrusive Modbus RTU