6611. Commissioning (optional equipment settings)...................................................................
6611.1. EWG 01.1 electronic position transmitter
6711.1.1. Measuring range: set
6811.1.2. Current values : adjust
6811.1.3. LED end position signalling: switch on/off
6811.2. Potentiometer
6911.2.1. Potentiometer: set
6911.3. RWG electronic position transmitter
7011.3.1. Measuring range: set
7011.4. Mechanical position indicator: set
7212. Corrective action....................................................................................................................
7212.1. Faults during commissioning
7212.2. Fault indications and warning indications
7612.3. Fuses
7612.3.1. Fuses within the actuator controls
7712.3.2. Fuse replacement
7712.3.2.1. Replace fuses F1/F2
7812.3.2.2. Test/replace fuses F3/F4
7812.3.3. Motor protection (thermal monitoring)
8013. Servicing and maintenance...................................................................................................
8013.1. Preventive measures for servicing and safe operation
8113.2. Disconnection from the mains
8213.3. Maintenance
8313.4. Disposal and recycling
8414. Technical data.........................................................................................................................
8414.1. Technical data Multi-turn actuators
8714.2. Technical data Actuator controls
9314.3. Tightening torques for screws
9415. Spare parts.............................................................................................................................
9415.1. Multi-turn actuators SAEx 07.2 – SAEx 16.2/SAREx 07.2 – SAREx 16.2 KT/KM
9615.2. ACExC 01.2 KL-Ex d actuator controls
100Index........................................................................................................................................
4
SAEx 07.2 – SAEx 16.2/SAREx 07.2 – SAREx 16.2 Control unit - electromechanical
Table of contents ACExC 01.2 Intrusive Profinet
To Next Page
Loading...
Need help?
General
