AUMA SGExC 05.1 - Page 81

Information: Please state type and commission no. of the device (see name plate) when ordering spare parts.
Only original AUMA spare parts should be used. Failure to use original spare parts voids the warranty and exempts
AUMA from any liability. Delivered spare parts may slightly vary from the representation in these instructions.
TypeDesignationNo.
Sub-assemblyLocal controls002.0
Sub-assemblyLocal controls board002.3
Sub-assemblyFace plate for display002.4
Sub-assemblyPower supply unit006.0
Sub-assemblyI/O board008.1-1
Sub-assemblyFieldbus board008.1-2
Sub-assemblyLogic board009.0
Sub-assemblyRelay board011.1
Sub-assemblyOption board012.1
Sub-assemblyCover500.0
Sub-assemblyPin carrier (without pins)502.0
Sub-assemblyPin for controls505.0
Sub-assemblyPin for motor506.0
Sub-assemblySwitchgear508.0
Padlock509.1
Sub-assemblyFuse kit510.0
Sub-assemblyTerminal frame (without terminals)528.0
End piece529.0
Sub-assemblyCable conduit (actuator connection)532.0
Terminals for motor/controls533.0
Circlip535.1
Sub-assemblyPlug-in electrical connection573.0
SetSeal kitS
81
SGExC 05.1 – SGExC 12.1 Control unit: electromechanic
ACExC 01.2 Intrusive Modbus RTU Spare parts