Wiring
Centre
Checklist
The Wireless Coordinator must be in pairing mode.
Ensure the wiring centre and optional system receiver
(Configured to RX1) for remote boiler switch are powered up.
Note: The wiring centre and system receivers will automatically
join the Zigbee network when powered up and the Wireless
Coordinator is in pair mode. Red LED on Wiring Centre and RX1
will go steady when the devices have joined the Zigbee network.
If more than one wiring centre is in the system, establish and note the wiring centre
number by pressing the network key for 1 second. The wiring centre number will
flash.
33
www.speedfitUFH.co.uk
1
2
3
Installation - Pairing with Wiring Centre
INSTALLATION
To Next Page
Loading...
