Checklist
The coordinator must be in pairing mode.
The system receiver (set to RX1) is powered up and
the red LED is steady. The Boiler Receiver will auto join
the Zigbee network on power up when the Wireless
Coordinator is in Pairing mode.
System Receiver configured to
boiler receiver RX1. Refer to Boiler
Receiver Instruction Manual.
This configuration option is applicable if there is only
a Boiler Receiver RX1 in the system.
Used if system receiver is installed on its own.
44
JGSTATW Instruction Manual
1
2
Installation - Pairing with Boiler Receiver Only
To Next Page
Loading...
