Use to
increase
temperature
to 30ºC
and then
press
Use to
decrease
temperature
to 10ºC
and then
press
If you are using the optional system receiver configured to RX1 please check that
the green light goes on when the temperature is raised and off when reduced.
If pairing for your system is complete, please take the coordinator
out of pair mode. Press for 5 seconds and light will stop flashing.
40
JGSTATW Instruction Manual
Installation - Testing Wireless Pairing
You should
hear the
valve open.
You should
hear the
valve close.
To Next Page
Loading...
