Aura JGSTATW2W - Installation - Pairing with Single Room Receiver

JGBR
Configured
as RX2
single
room
receiver.
Checklist
The Coordinator must be in pairing mode.
The JGBR (set to RX2) is powered up and the red LED is
steady. Refer to JGSTATW Instruction Manual.
If you are using the optional JGBR configured to RX1 for remote boiler
switching, ensure this has been powered up and the red flashing LED has
gone steady. Refer to JGBR Instruction Manual.
Refer to JGBR
Instruction Manual.
41
www.speedfitUFH.co.uk
Installation - Pairing with Single Room Receiver
1
2
3
INSTALLATION