04
JGSTATW Instruction Manual
Product Compliance & Safety Information
Emergency. Switch off the
voltage to the individual
thermostat, wiring centre or
complete system.
Sources of danger. The
thermostat must be disconnected
from mains supply before
removing the cover.
For the installer. Please enter
any parameter changes in the
Installer Notes section (pages
90 and 91).
Installer parameter settings.
Aura Wireless Thermostats are
equipped with an Installer
Parameter section (see page 40).
This must only be entered by the
installer or a competent person.
Changing these parameters can
have a serious effect on your
heating system.
230V AC
Warning. This product must be
fitted by a competent person.
Installation must comply with the
guidance, standards and
regulations applicable to the
location where the product is
installed. Failure to comply with the
requirements of the relevant
guidance, standards and
regulations could lead to
prosecution, injury or death.
These instructions are applicable to the
Aura models stated on the front cover of
this Instruction Manual only.
Warning. Always isolate the
AC Mains supply before
installing or working on any
components that require 230v
AC 50Hz supply.
To Next Page
Loading...
