EasyManua.ls Logo

Aurora PVI-AEC-EVO - Page 20

Aurora PVI-AEC-EVO
106 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18-EN
Note: To make the system fully functioning it is essential that the same system is constantly connected
to the internet so that it is able to communicate with the Power-One server. This is essential to
graphically showsthe data on webpages as wellas for sending alarm and/orreport messages.Itis
essential that the LAN network in which the PVI-AEC-EVO is wired is such that it allows the
connection to the IP address 63.236.63.180 to be reached through port 80, so that the
PVI-AEC-EVO isabletocommunicatewith theportalmanagementserver.
Inorder toallow the PVI-AEC-EVO tocommunicatewith theAuroraVisionweb portal,access the configurationpage
(CONFIG) of the network (NETWORK) and check that in section 'DATA TRANSFER', under item 'IP Address Portal'
thereisthe IPaddress .63.236.63.180
Note: If the setting 'IP Portal Address' does not correspond to 63.236.63.180, change it by entering the
above-mentioned address and press 'Confirm' to activate it.After this operation, reset the system
(ON-OFF).
Monitoring System
EN - ENGLISH
Hundredths of degree)
ouble quotation mark*
33
35
system to the local
and type into the
FIG) of the system
system.

Table of Contents