D 900 AP / D 1000 AP / D 1000 APG
24
Operating
the dumper
Emergency start
If the engine cannot start due to a flat battery, another 12V booster battery can be used
together with the corresponding jump leads to connect the two batteries. If you use the
battery of another machine or dumper, avoid the two machines touching.
1- Apply the dumper’s parking brake.
2- Open the dumper engine cover.
3- Connect the (+) positive terminal of the battery with the (+) terminal of the
dumper and with the other cable connect the (-) negative terminal with the (-) of
the dumper.
4- Start the dumper in the normal way.
5- Disconnect the cables from the terminals, first the (+) positive terminals and then
the (-) negative terminals.
Parking the dumper and stopping the engine.
Whenever the dumper is parked, either at the end of the day or in order to carry out any
maintenance work, it should be parked on level ground. Apply the dumper’s parking
brake. Keep the engine in idle for 1 minute, if the dumper has been working at full load.
Then turn the ignition key in and anti-clockwise direction to stop the engine. Connect the
gear stick in such a way that it creates additional holding for the machine in case of the
parking brake failing. Chocking the wheels with suitable blocks is also recommended.
Remove the key from the ignition and take it with you. Never leave the key in the parked
dumper.
To Next Page
