D 900 AP / D 1000 AP / D 1000 APG
56
(fi g. 1)
13.- Cable lubrication (fig. 1)
All cables must be lubricated with cable lubricant.
WARNING!!
Using another lubricant could cause the cable or control to malfunction (accelerator
pedal, etc.). Always wear eye protectors and gloves when lubricating cables.
14.- Body/Chassis
Engine Area
Check the engine compartment to see if there is any damage or leak. Ensure that all
rubber hoses are free from cuts, splits, cracks or damage of any kind and that the fittings
are correctly fitted. Examine the support devices of exhaust, battery and tanks.
Check the electrical connections for corrosion and tension on the cables.
Replace or repair damaged parts.
Chassis supports
Check the condition and tighten all dumper supports. Retighten if necessary.
Seatbelt
Check the fixture and lock of the seatbelt. Before starting the day, carefully inspect this
devices with special attention to:
- Cuts or threading on the belt
- Wear or damage to anchor points
- Poor functioning of the seat belt buckle or the retracting roller
- Loose threads or poor stitching
Consult an authorised AUSA dealer for the replacement of damaged parts.
Dumper cleaning and protection
Never use water at high pressure to clean the dumper. ONLY USE LOW PRESSURE
WATER. High pressure water can cause electrical and mechanical damage.
Damaged painted parts must be repainted to prevent corrosion.
When required, wash the body with soap and water (use only neutral soap) Apply non-
abrasive wax.
CAUTION:
Never clean plastic parts with inappropriate detergent, degreasing agents, solvents,
acetone, etc.
Periodic
maintenance
operations
To Next Page
