AUSA D 900 AP - ROPS Protector Arch Folding

D 900 AP / D 1000 AP / D 1000 APG
25
 Procedure for folding the ROPS protector arch (fig. 1, 2, 3, 4)
The ROPS folding protector arch is comprised of two sections (h) and (i) can pivot to
approximately half of its length allowing it to be folded towards the rear of the machine
and thereby reducing the total height of the machine for transport purposes.
Transport position
WARNING
Do not work with the machine if the ROPS protector arch is in the Transport
position.
To place the ROPS protector arch in this position follow the instructions below:
1- Remove the two locks (j) from the bolts (k) located on each side of the ROPS
protector arch.
2- Remove the bolts (k).
3- Carefully fold the top part of the ROPS protector arch (h) backwards to the
Transport position.
4- Once it is correctly positioned (fig. 4), replace the bolts (k) and then the locks
(j).
Working position
To place the ROPS protector arch in this position follow the instructions in the reverse
order.
WARNING
Carefully ensure you position your feet on the machine or on the floor in a
stable position to ensure that you do not lose your balance whilst folding back
the ROPS protector arch. Similarly, take care to not place you hands around
the protector arch fold area (as shown in fig.5) as this could cause serious
injury.
(fi g. 5)
(fi g. 4) (fi g. 3) (fi g. 2) (fi g. 1)
Operating
the dumper
a
h
a
k
a
j
a
i
a
h