AUSA D 900 AP - Page 60

D 900 AP / D 1000 AP / D 1000 APG
58
Maintenance chart
EVERY
I: Inspect, verify, clean, lubricate, replace if necessary
Initial Inspection (50 h)
125 h. 500 h. 750 h.
1000 h
1500 h. 3000 h.
Every week
Every month
Every year
Every 2 years
To be performed by
C: Clean
L: Lubricate
R: Replace
GREASING POINTS
Central pivot L USER
Nipples (see section "Greasing points" in this Manual) L USER
Cables and articulations (throttle, lifting rams...) L USER
TRANSFER BOX
Oil (1) I R I R USER
Oil leaks I USER
Screws and nuts torque I USER
AXLES (FRONT AND REAR)
Oil (1) I R I R USER
Oil leaks I USER
Fixation wheel nuts torque I USER
Chassis fixation screws (torque) I DEALER
Cardan joint fixation screws (torque) I DEALER
Flange fixation nut (torque) I DEALER
Adjust wheel hub bearings I CLIENTE
Condition of tires and pressures I USER
BRAKES
Brake fluid (3) I R DEALER
Handbrake adjustment (3) I I USER
BODY / FRAME
ROPS frame I USER
Seat belt (3) I USER
Foot plate, access steps and handles (3) I/C USER
Guards and covers (3) I USER
Plates and decals (3) I/C USER
Central pivot nut torque I DEALER
Safety systems / articulated blocking linking bar and safety prop I USER
Engine side covers and locks (3) I USER
(1) Initial inspection. The initial maintenance is very important and must not be neglected.
(2) To be performed by an authorized AUSA dealer.
(3) Daily inspection item.
(4) More often under severe use such dusty areas, sand, snow, wet or muddy conditions.
(5) Or after cleaning 6 times.
(6) Replace if it’s necessary.