LIUSK8B00_eng-01AUTEC
27
8.9.2 Power keyswitch + PIN code art up
WARNING: Make sure that a PIN code for art up is enabled in the Transmitting
Unit. In fact, if a PIN code is not enabled for art up in the Transmitting Unit,
the following procedure may art the Machine at fir activation of the START.
When the Receiving Unit is correctly powered on, perform the following procedure; activate
each command within 3 seconds after releasing the previous one:
1. Insert a fully charged battery in the Transmitting Unit (see paragraph 8.6.1).
2. Insert the power keyswitch in the Transmitting Unit (see paragraph 8.1).
3. Make sure that the GSS or EMS pushbutton is not pressed.
4. Activate START and hold it active until the green LED illuminates.
5. Activate the commands corresponding to PIN code in the correct sequence (PIN 1, PIN 2 and
PIN 3 given in the Technical Data Sheet).
a. PIN 1 shall not be included in the art up procedure if it corresponds to START.
b. PIN 3 shall not be included in the art up procedure if it corresponds to START.
6. Activate START and hold it active until the green LED blinks fa.
7. Release START.
When the green LED blinks slowly, the Radio Remote Control is arted.
Note: the default PIN code set by Autec is the following:
- PIN 1 = START
- PIN 2 = FUNCTION
- PIN 3 = START
Autec will set a cuomized PIN code only upon reque by the Machine Manufacturer
or the Inaller.
8.9.3 Procedure to modify the PIN code
If a PIN code is needed for the Transmitting Unit, it can be modified to limit the use of the Radio
Remote Control.
To modify the PIN code, perform the following procedure with the Transmitting Unit switched
off and the GSS or EMS pushbutton released.
1. Enable command S0 and START and keep them enabled until the green LED blinks (1 blink
per second).
2. Activate the commands of the PIN code sequence provided in the Technical Data Sheet.
3. Activate command S1 (see Technical Data Sheet) repeatedly until LED 2 illuminates.
To Next Page
Loading...
