AUTEC Air series - Warnings for installation

LIUSK8B00_eng-01 AUTEC
28
4. Activate command S2 (see Technical Data Sheet) to con󰘰rm your selection (green LED blinks
twice per second). You can choose the 3 commands you want to set as PIN code among󰘵 all
the commands on the Unit.
- If you want to 󰘵art the Radio Remote Control with a single-command PIN code, enable
START as PIN 1 and PIN 3.
- If you want to 󰘵art the Radio Remote Control with a two-command PIN code, enable START
as PIN 1 or PIN 3.
5. Activate the command you want to allocate as PIN 1 (LED 1 and green LED are 󰘵eady on).
6. Activate the command you want to allocate as PIN 2 (LED 2 and green LED are 󰘵eady on).
7. Activate the command you want to allocate as PIN 3 (LED 3 and green LED are 󰘵eady on). PIN
code is saved automatically.
8.10 Command activation
When the Radio Remote Control is 󰘵arted, it is possible to activate movements, functions and
commands on the Machine by acting on the related pushbuttons or switches, whose functions
and symbols are decided by the Manufacturer and/or the In󰘵aller.
To identify the relation between the actuators and the corresponding Machine movements, the
Machine Manufacturer and/or the In󰘵aller shall provide relevant in󰘵ructions and the User shall
be properly trained.
8.11 Interruption of the radio link
When the radio link is incorrect or interrupted, the automatic 󰘵op function activates (see
paragraph "Control devices" in the In󰘵ruction Manual's general part).
The green LED of the Transmitting Unit signals this interruption by switching from slow blinking
to one of the following 󰘵atuses (see chapter 11):
- fa󰘵 blink;
- on with 󰘵eady light;
- two blinks and a pause;
- three blinks and a pause.
8.12 Transmitting Unit automatic switch o󰓐
Automatic switch off of the Transmitting Unit occurs in the following cases:
- When the battery is 󰘱at (see paragraph 8.12.1).
- When the Radio Remote Control is not used for a certain time (see paragraph 8.12.2).
To start the Radio Remote Control, see paragraph 8.9).
8.12.1 Low battery
The Transmitting Unit indicates if the battery is not sufficiently charged.
- The red LED blinks slowly (one blink per second): the Transmitting Unit has about 1-hour run
time after the onset of signal.
- The red LED blinks fa󰘵: the Transmitting Unit has a 10-minute run time from the onset of
signal, after which the Transmitting Unit will automatically switch o󰘯.
It is necessary to bring the Machine to a safe 󰘵ate and replace the battery with a charged one
(see paragraph 8.6).