LIUSK8B00_eng-01AUTEC
33
8.16 BACK-UP UNIT
If the Transmitting Unit cannot be used, it can be replaced with a Transmitting Unit called BACK-
UP UNIT; you need to ask for it from Autec.
It is identical to the Unit that cannot be used any more; the only difference is the presence of
the plate “BACK-UP UNIT” on the battery housing.
Insert in the BACK-UP UNIT the ID internal tx memory of the Transmitting Unit
that cannot be used any longer and perform the address orage procedure
described below.
As required by andard IEC 60204-32, each Radio Remote Control is uniquely
identified through a serial number (S/N). Therefore, upon replacement of the
Unit, the serial number of the Transmitting Unit to be replaced mu be written
on the BACK-UP UNIT, so that all the Units belonging to the Radio Remote
Control show the same serial number.
Autec cannot be held responsible if the serial number of the Transmitting Unit
to be replaced has not been marked on BACK-UP UNIT.
8.16.1 Address orage
Perform the following procedure with fully charged battery and power keyswitch inserted in the
BACK-UP UNIT:
1. Activate START and hold it active until the green and red LEDs illuminate and an acouic
signal sounds.
2. Wait until the green LED blinks slowly.
3. within 3 seconds, activate in sequence the pushbuttons related to PIN 1, PIN 2 and PIN 3 that
compose the PIN code provided in the Technical Data Sheet.
If the PIN code is incorrect, the red LED illuminates and the Transmitting Unit switches off. In
this case, the orage procedure shall be repeated.
If the PIN code is correct, the green LED turns eady on and the Transmitting Unit switches
off: this indicates that the address has been ored in the BACK-UP UNIT.It is now possible to
art the Radio Remote Control and control the Machine with the BACK-UP UNIT Transmitting
Unit.
To Next Page
Loading...
