AUTEC Air series - Page 32

LIUSK8B00_eng-01 AUTEC
32
8.15.2 Operation
Before 󰄋arting to work, make sure that the cable and the corresponding
connectors are intact.
Work organisation, Machines' position, passages, etc. shall be planned so
as to avoid that the cable control 's cable may be damaged by moving trolleys
or by the ongoing operations.
Do not use the cable control's cable to lift the Transmitting Unit.
Lay the cable control's cable in such a way as to avoid that it is squashed or
󰄋rained by People or objects. Avoid contact with sharp or cutting objects
that can cut the cable's protective sheath.
Using the cable control at the same time as the wai󰄋 belt or the shoulder
harness means that there is a physical connection between the User and the
Machine: therefore, the User mu󰄋 con󰄋antly check that the Machine's
movements, especially in case of loss of control (by way of example: risk of
overturning, of cable dragging by other Machinery), do not cause hazards. In
such situations, the User mu󰄋 pull out the belt or open it by unfa󰄋ening its
buckle(s).
The cable control mu󰘵 only be connected and disconnected when the Transmitting
Unit is off.
When you finish working with the cable control, disconnect the cable from the
Transmitting Unit and from the Machine, and protect the connectors with their caps.
To control the Machine after the cable control has been connected or disconnected, 󰘵art the
Radio Remote Control (see paragraph 8.9).
When working with the cable control:
- Radio link is cut o󰘯.
- Leave the battery inside the Transmitting Unit, even though the power supply comes from the
Receiving Unit. The battery is not, in any case, recharged through the cable control: it can only
be recharged through its appropriate battery charger provided together with the sy󰘵em.