AUTEC Air series - Switching off the Transmitting Unit

LIUSK8B00_eng-01AUTEC
29
The battery run time signalled by the Transmitting Unit is reduced by the following
factors:
- Battery ageing
- Increasing number of battery charge-discharge cycles
- Battery usage outside the range provided in paragraph "Operational usage" in
"Part A" of the Manual.
- Battery 󰘵orage in disregard of the indications given in paragraph "Storage" in the
in󰘵ruction manual for the use and maintenance of the battery and battery charger.
8.12.2 When the Transmitting Unit is not used
If the Transmitting Unit remains 󰘵arted with no enabled commands, it will automatically switch
off after a predetermined time frame. This time frame is specified in the Technical Data Sheet
(SWITCH-OFF).
Before the Transmitting Unit switches off automatically, the green and red LEDs blink alternating
for 30 seconds.
Activating any actuator corresponding to a movement command reduces the predetermined
automatic switch-off time (SWITCH-OFF) to zero.
Setting or removal of the automatic switch off time (SWITCH-OFF) is done by Autec
and decided by the Machine Manufacturer or by the In󰘵aller, depending on the
operation and functions they need on the Machine.
8.13 Switching o󰓐 the Transmitting Unit
Switch off the Transmitting Unit when not actively using the Radio Remote
Control to operate the Machine, or when work is otherwise interrupted, even
for short periods. Do not leave the load hanging or the Machine in dangerous
conditions (even when charging the Unit or changing the battery).
FAILURE TO DO SO CAN RESULT IN SERIOUS BODILY INJURY OR DEATH
AND/OR PROPERTY DAMAGE.
Voluntary switch off of the Transmitting Unit occurs in the following cases.
- When the battery is removed (see paragraph 8.6.2).
- When the power keyswitch is removed (see paragraph 8.1).