AUTEC Air series - Before starting to work

LIUSK8B00_eng-01 AUTEC
40
Signals Possible reasons Solutions
The green LED blinks slowly (one
blink per second).
The Receiving Unit may not work
correctly.
See "Malfunctions signalled by
the Receiving Unit " in Part D of
the Manual.
The red LED blinks twice per
second at Radio Remote
Control's 󰘵art up.
At lea󰘵 one of the commands
that were checked at 󰘵art-up is
enabled (see Technical Data
Sheet).
Move the actuators related to the
commands monitored during the
󰘵art up to the re󰘵 position.
The red LED blinks three times
per second at Radio Remote
Control's 󰘵art up.
The battery is flat.
Replace the battery with a
charged one.
The red LED is 󰘵eady on for two
seconds at Radio Remote
Control's 󰘵art up.
The Transmitting Unit does not
work correctly.
Contact the support service of
the Machine Manufacturer.
The green LED and the red LED
are 󰘵eady on at Radio Remote
Control's 󰘵art up.
Wrong Key ID 0-1 or ID internal tx
memory has been inserted in the
Transmitting Unit.
Use the correct Key ID 0-1 or ID
internal tx memory.
You're using a BACK-UP UNIT
with the Key ID 0-1 or ID internal
tx memory of the Transmitting
Unit that has been replaced.
Store the address in the
BACK-UP UNIT (see paragraph
8.16).
The green LED and the red LED
blink three times per second at
Radio Remote Control's 󰘵art up.
The Key ID 0-1 or ID internal tx
memory is damaged.
Contact the support service of
the Machine Manufacturer.
The green LED is 󰘵eady on and
the red LED blinks twice per
second at Radio Remote
Control's 󰘵art up.
START is active. Release START.
The green LED repeats the
sequence three blinks and a
pause, and the red LED is 󰘵eady
at Radio Remote Control's 󰘵art
up.
The UNPAIR procedure provided
in the document "Menu of
Transmitting Unit (MTU)" has
been carried out.
Perform the ALIGNMENT
procedure.
The green LED and the red LED
are off at Radio Remote Control's
󰘵art up
The GSS or the EMS pushbutton
is pressed.
Unlock the GSS or the EMS
pushbutton.
The power keyswitch is not
inserted.
Insert the power keyswitch.
The battery is completely
discharged or not inserted.
Insert a charged battery.