11
4.1.2 Preparing Installation Tools
You may need the following tools during installation:
Scissors
Power Drill
Drill Bit (8 mm)
Step Bit (30 mm)
Phillips Bit (PH2)
Marker
Tape Measure
Wire Stripper
Torque Driver
(2 N·m)
Multimeter
Flathead
Screwdriver
NOTE
The tools listed above are excluded from the package.
4.1.3 Location Requirements
Install your charger on a flat and vertical surface capable of supporting its weight (e.g., a finished wall or
pedestal).
Position the charger in a location where it is not vulnerable to being damaged.
Allow the charging cable to sufficiently reach the vehicle’s charging port without any strain.
To Next Page
Loading...
