20
To perform Automatic Selection
1. Tap the Diagnostics application button from the MaxiPRO Job
Menu. The Vehicle Menu displays.
2. Tap the manufacturer button of the test vehicle.
3. Tap Automatic Selection and the VIN information will be acquired
automatically. Follow the on-screen instruction to display the
diagnostic screen.
Manual Selection
When the vehicle’s VIN is not automatically retrievable through the vehicle's
ECU, or the specific VIN is unknown, the vehicle can be manually selected.
This mode of vehicle selection is menu driven, repeat the first two steps
from the automatic selection operation and tap Manual Selection. Through
a series of on-screen prompts and selections, the test vehicle is chosen. If
needed, press the Back button at the bottom right corner of the screen to
return to previous screen.
Navigation
Navigating the Diagnostics interface and selecting test are discussed in this
section.
To Next Page
Loading...
