65
1) Use the UP/DOWN scroll button to select I/M Readiness from
Diagnostic Menu and press the Y button (Figure 6-3).
2) Wait a few seconds while the scan tool validates the PID MAP.
3) If the vehicle supports both types of tests, then both types will be
shown on the screen for selection.
Figure 6-14
4) Use the UP/DOWN scroll button, as necessary, to view the status of
the MIL light (ON or OFF) and the monitors.
Figure 6-15
5) If the vehicle supports readiness test of “This Drive Cycle”, a screen of
the following displays:
To Next Page
Loading...
