3 End User Operation
3.2.2 Status – History
Figure 3.2.2.i Status – History
Press in the Status screen in Figure 3.2.1.i to show the Status History. The setpoint, actual
temperature/pressure and firing rate are displayed graphically.
This data is logged for 24 hours on the MM. Use the buttons to change the timescale of the
data displayed, and press and drag on the axis to zoom in/out of the graph.
This information is logged for 2 years on the DTI when connected with the MM.
Note: Power cycling the MM or changing fuel will reset the 24 hour history data log on the MM.
Page 14 Mk8 MM End User Guide 22.05.2017
To Next Page
Loading...
