AUTOFLAME Mk8 MM - 3 COMMISSIONING PROCEDURE; 3.1 Overview

In addition to when there is a setting conflict, the MM will be forced into commission mode if any of the
forced commission reason occurs.
Forced Commission Message
Fuel not commissioned.
 Selected fuel must be commissioned.
Servo configuration does not match commissioning.
 Option 8 and/or expansion option 80 do not match the last commission settings.
VSD configuration does not match commissioning.
 VSD settings for channels 5 and 6 must be the same as the last commission settings.
Golden start optioned but not commissioned.
 Commission golden start position (see section 3.4.8).
FGR optioned but not commissioned.
 Commission FGR start position (see section 3.4.9).
Trim channel does not match commissioning.
 Option 76 trim channel must be the same as the last commission settings.
Fuel/air-rich trim ranges changed.
 Parameter 13 and/or parameter 19 do not match last commission settings.
BC Option/parameter mismatch.
 BC options 110 – 160 must be set the same as their corresponding parameters.
Invalid option value.
 An option value is outside the allowed range.
Invalid parameter value.
 A parameter value is outside the allowed range.
Invalid expansion option value.
 An expansion option value is outside the allowed range.
Options have been reset.
 Option settings have been reset due to data lost in an EEPROM error.
Parameters have been reset.
 Parameter settings have been reset due to data lost in an EEPROM error.
Expansion options have been reset.
 Expansion option settings have been reset due to data lost in an EEPROM error.
VPS sensor not commissioned.
 Gas pressure sensor has been enabled but not commissioned.
Commissioned gas pressure during valve proving too low.
 Gas pressure stored during valve proving is less than option/parameters 133 and/or 136.
Commissioned running gas pressure too low.
 Gas pressure at one or more commissioned points is less than option/parameter 136.
APS sensor not commissioned.
 Air pressure has been enabled but not commissioned.
Commissioned air pressure too low.
 Air pressure at one or more commissioned points is less than option/parameters 147 and/or 149.
IR Upload was completed successfully, check configuration then restart.
 Check data has uploaded successfully before restarting in run mode.
22.05.2017 Mk8 MM End User Guide Page 62
4 Errors and Lockouts
4.5 Forced Commission Reasons