AUTOFLAME Mk8 MM - Page 7

1 Overview and Benefits
Page 2 Mk8 MM End User Guide 22.05.2017
 15 First out annunciation inputs
 4 fuel commission curves possible
 24 hour history graphical information on MM when powered on
 Custom boiler display configuration
Water Level Control
 Fully modulating feed water control with servomotor and VSD as well pump on/off
 Capacitance probes for patented wave signature level detection
 Water level alarms 2
nd
low, 1
st
low, high water and optional pre 1
st
low and pre-high water
 Conductivity probe for auxiliary 2
nd
low alarm
 Automatic bottom blowdown with time reduction for blowdown savings
 Continuous modulating top blowdown control to maintain TDS in water
 Steam/ hot water flow metering to calculate flow rates based on temperature sensor
Exhaust Gas Analyser (EGA)
 3 Parameter trim of O
2, CO2 and CO
 Analysis of O
2, CO, CO2, NO, exhaust gas temperature, efficiency and delta temperature
 Optional analysis of NO
2 and SO2
 Local display for re-calibration, changing cells, user configuration and standalone operation
 Upper/lower offset and absolute limits for O
2, CO, CO2, NO and exhaust gas temperature
 Six 4-20mA output signal for interface with other controls/chart recorders
Intelligent Boiler Sequencing
 System will sequence hot water boilers or steam boilers via lead/lag distribution
 Fully adjustable user options within the system to tailor sequencing operation to the application
 System control for isolation of valves or pumps (2 port valve operation)
 Standby setpoint and warming for lag boilers via a standby pressure and timing sequence
 Lead boiler and lag boiler warming modes selection
Remote Control and Data Transfer Interface (DTI)
 Direct Modbus communications from MM including remote setpoint and firing rate adjustment,
burner enable/disable (without DTI or intelligent boiler sequencing)
 DTI will collect operational data for up to 10 MM modules, 10 EGA modules and 10 universal
I/O modules in one communications loop
 Information transmitted via RS422 or Ethernet link to local PC/network for running Autoflame
CEMS Audit software