To Next Page

To Previous Page

The blue and green wires are multiplex inputs. They are both tied to the same zone. If an input of less than 0.8

seconds is supplied to either wire the Warn Away response will occur. An input longer than 0.8 seconds to either

wire will initiate the triggered sequence and report zone 4.

system features learn routine

The System Features Learn Routine dictates how the unit operates. It is possible to access and change any of

the feature settings using the Valet

/program switch. However, this process can be greatly simplified by using

the optional Personal Computer Interface, or DEI

Bitwriter

™

. Any of the settings can be changed and then

assigned to a particular transmitter, up to four, a feature called Owner Recognition. Each time that particular

transmitter is used to disarm the system, the assigned feature settings will be recalled. Owner Recognition is

only possible when programming the unit via the computer interface or DEI

Bitwriter

™

. If programming with the

PC interface or the DEI

Bitwriter

™

, the learn routine can be locked or unlocked. If it is locked no features can

be changed.

To enter the System Features Learn Routine:

1. Open a door. (The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)

2. Turn the ignition on, then off. (The YELLOW wire, H1/9 must be connected.)

3. Select a feature. Press and release the Valet

/program switch the number of times corre-

sponding to the feature you wish to change. For example, to access the third feature, press

and release the Valet

/program switch three times. Then press the Valet

/program switch

once more and HOLD it. The siren will chirp the number of times equal to the step you

have accessed.

4. Program the feature. While HOLDING the Valet

/program switch, you can toggle the

feature on and off using the remote transmitter. Pressing the button that arms the system

will select the one chirp setting. Pressing the button that is assigned to channel 2 (or the

disarm only button when in OEM configuration, see Transmitter/Receiver Learn Routine

section of this guide), will select the two chirp setting.

BLUE, GREEN wires

Automate 425 User Manual

Questions and Answers: