Automatic Technology DOMINATOR EasyRoller 14 - Coding Transmitters; Set Transmitter Codes; Remotely Code Transmitters; Code for Vacation Mode

20
Dominator EasyRoller Instruction Manual
6.10 Coding Transmitters
6.10.1 Setting Transmitters Codes
WARNING! The manufacturer is not responsible for
any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could
void the user’s authority to operate the equipment.
AVERTISSEMENT! Le fabricant n’est pas responsable des
éventuelles interférences avec la réception de la radio
ou de la TV due à une modification de cet équipement
effectuée sans autorisation. De telles modifications
peuvent invalider le droit à utiliser l’équipement.
The opener can only be operated from remote
controllers that have been programmed into its
memory. Up to 64 remotes can be programmed.
tip
STEP ONE
STEP TWO
Take a pre-coded
remote and press the
button to duplicate
REMOTELY CODING A REMOTE CONTROL
Remotely coding works when you have a
pre-coded remote control and are in range of the
opener.
tip
Use a pen,
HOLD for 2 sec
the middle button
through the
coding hole
STEP THREE
Opener ashes & beeps
HOLD for 3 sec
HOLD for 3 sec
RELEASE
Take new
remote
RELEASE
STEP FOUR
Press to test
Opener stops ashing &
beeping
STEP ONE
HOLD
Opener beeps
HOLD for 3 sec
HOLD for 3 sec
RELEASE
Release both
buttons
STEP TWO
Press to test
The opener can only be operated from remote
controllers that have been programmed into its
memory. Up to 64 remotes can be programmed.
tip
STEP ONE
STEP TWO
Take a pre-coded
remote and press the
button to duplicate
REMOTELY CODING A REMOTE CONTROL
Remotely coding works when you have a
pre-coded remote control and are in range of the
opener.
tip
Use a pen,
HOLD for 2 sec
the middle button
through the
coding hole
STEP THREE
Opener ashes & beeps
HOLD for 3 sec
HOLD for 3 sec
RELEASE
Take new
remote
RELEASE
STEP FOUR
Press to test
Opener stops ashing &
beeping
STEP ONE
HOLD
Opener beeps
HOLD for 3 sec
HOLD for 3 sec
RELEASE
Release both
buttons
STEP TWO
Press to test
Remote code set is disabled when:
• powered by battery backup
• the service indicator is active
• when the door is indifcating that it as
prevented from closing by a P.E beam
being blocked.
tip
6.10.2 Remotely Coding Transmitters
VACATION MODE
STEP THREE
HOLD
Opener beeps
2 times
HOLD for 3 sec
HOLD for 3 sec
RELEASE
Release all buttons
STEP FOUR
Then ret
controls cover
STEP ONE
STEP TWO
Remove controls cover
Press once
+
STEP FIVE
Turn on
HOLD for 4 sec
RELEASE
Turn off
Press, then
try another
remote
AUX OUTPUT
STEP THREE
HOLD
Opener beeps
3 times
HOLD for 3 sec
HOLD for 3 sec
RELEASE
Release all buttons
STEP FOUR
Then ret
controls cover
STEP ONE
STEP TWO
Remove controls cover
Press twice
+
STEP FIVE
Press to test
6.10.3 Coding for Vacation Mode 6.10.4 Coding for AUX Output