Autonics TM4-N2RB - Communication Stop Bit; Response Wait Time; Enable;Disable Communications Writing

6 Parameter Settings and Functions
© Copyright Reserved Autonics Co., Ltd. 79
6.5.4 Communication stop bit
You can set the number of bits to mark the end of a transmitted data string.
Setting value
Description
1 Sets end of data string to 1 bit.
2 Sets end of data string to 2 bit.
Setting group Parameter Setting range
Factory
default
Unit
Communication Setting Stop Bit 1, 2 2 -
6.5.5 Response wait time
Set a standby time to mitigate communication errors when communicating with a slow master
device (PC, PLC, etc.). Once a standby time is set, the controller will respond after the defined
standby time has elapsed.
Setting group Parameter Setting range
Factory
default
Unit
Communication Setting
Response Wait
Time
5 to 99 20 ms
Shorter standby times can cause communication errors in the master device.
6.5.6 Enable/Disable communications writing
This feature can change parameter settings stored in memory through communication with PC,
GP, PLC, etc., in order to permit or prohibit writing.
Setting value
Description
ENABLE Parameter set/change enable via communication.
DISABLE Prohibit parameter setting or modification via communication.
Setting group Parameter Setting range
Factory
default
Unit
Communication Setting
Communication
Write
ENABLE, DISABLE ENABLE -
Reading parameter settings is always permitted.