Autonics TM4-N2SB User Manual

5 Preparation and Startup
© Copyright Reserved Autonics Co., Ltd. 37
5 Preparation and Startup
5.1 General process
Before operating TM Series for the first time, do the following:
1st Connect all external devices, sensor and load to the TM Series.
2nd Set parameter values through external connecting devices (PC loader program, GP etc.).
3rd Download the parameters to TM Series.
4th Proceed with auto-tuning or set control variables, and then start control.
For using comprehensive devicem management program ‘DAQMaster, parameters are
automatically downloaded at the time when they are changed.
5.2 Setup values when power ON
Setting category Factory default
Previous
setting value
Power ON
setting value
Auto/Manual Auto
Auto Auto
Manual Manual
RUN/STOP RUN
RUN RUN
STOP STOP
PID/ONOFF PID
PID Maintains preset value
ONOFF Maintains preset value
MV
0.0 Preset MV Maintains preset value
0.0 Stop MV Maintains preset value
0.0 Sensor Error MV Maintains preset value

Autonics TM4-N2SB Specifications

General

Brand	Autonics
Model	TM4-N2SB
Category	Temperature Controller
Language	English