Autronica AutroFlame X33AF

Other manuals for Autronica AutroFlame X33AF

Questions and Answers:

K
Kimberly MartinezJul 31, 2025
What to do if there is background IR radiation issue with Autronica AutroFlame X33AF Security Sensors?
- D
  David HoJul 31, 2025
  To address background IR radiation issues with Autronica Security Sensors, begin by checking for high levels of background IR radiation. You can do this by covering the detector with the factory-supplied cover or aluminum foil. If high levels are present, re-adjust the detector's view away from the IR source, or relocate the detector entirely.
C
carneydanaAug 4, 2025
How to fix wiring continuity issue in Autronica AutroFlame X33AF?
- A
  Allison YoungAug 4, 2025
  To resolve a wiring continuity issue with Autronica Security Sensors, turn off the input power to the detector and check all wiring for continuity.
H
Herbert OwensAug 8, 2025
What to do if Autronica Security Sensors show 'Hi Background IR Fault'?
- D
  Deanna CostaAug 9, 2025
  If your Autronica Security Sensors are showing a 'Hi Background IR Fault', you can try the following: * Check the system wiring. * Cycle the power. * Remove any nearby IR sources, or aim the detector away from them.
S
simsraymondAug 13, 2025
What to do if Autronica Security Sensors trigger a fire alarm?
- T
  tiffanygrossAug 13, 2025
  If your Autronica Security Sensors trigger a fire alarm, you should first check the system wiring. If the wiring is correct, try cycling the power to the sensors.
B
Bryan HowardAug 17, 2025
What to do if Autronica AutroFlame X33AF Security Sensors show general fault?
- M
  Marie WilliamsAug 17, 2025
  If you are experiencing a General Fault with your Autronica Security Sensors, check the system wiring and cycle the power.
J
Jason BassAug 22, 2025
What to do if Autronica AutroFlame X33AF Security Sensors show power fault?
- H
  Heather MooreAug 22, 2025
  If you are experiencing a Power Fault with your Autronica Security Sensors, check the system wiring and cycle the power.
J
Joseph Johnson DDSAug 26, 2025
What to do if Autronica AutroFlame X33AF Security Sensors show oi fault?
- R
  Richard BrownAug 27, 2025
  If you are experiencing an oi Fault with your Autronica Security Sensors, check the system wiring and cycle the power.

Autronica AutroFlame X33AF Specifications

General

Enclosure Material	316 Stainless Steel
Ingress Protection	IP66/67
Sensor Type	Triple IR (IR3)
Detection Range	Up to 60 meters
Field of View	90 degrees
Power Supply	18 to 32 VDC
Current Consumption	Max 100 mA at 24 VDC
Operating Temperature	-40°C to +70°C
Storage Temperature	-40°C to +85°C
Humidity	0 to 95% RH, non-condensing
Outputs	4-20 mA, HART, Relays
Approvals	ATEX, IECEx, FM, CSA