Need help?Do you have a question about the Autronica AutroGuard V-430 and is the answer not in the manual?
General| Brand | Autronica |
|---|---|
| Model | AutroGuard V-430 |
| Category | Security Sensors |
| Language | English |
Overview of the AutroGuard Multicriteria Protector product line and its series.
Defines the scope, target audience, and purpose of this technical handbook.
Lists related documents and sources for downloading technical information.
Critical safety warnings, warranty disclaimers, and liability limitations for product use.
Outlines the protector's intended application and relevant safety regulations.
Details compliance with international and national safety standards for product installation.
Guidelines for safe mounting, installation, commissioning, and maintenance procedures.
Prohibits product modifications and outlines responsibilities for altered products.
Information on product compliance with environmental standards and proper disposal methods.
Details dimensions, materials, ingress protection, and current consumption for protectors and bases.
Technical data for the integrated sounder, including sound pressure levels and tones.
Specifications for the integrated VAD, including intensity, coverage volume, and flash rate.
Explains the protector's chamber design and the DYFI3D particle/smoke analysis technology.
Details sensitivity classes, operation modes, and heat response categories for environmental adaptivity.
Describes the SelfVerify 2.0 automatic test function and the Cover Detection feature for detecting obstructions.
Guides on cable entries, routing, stripping, and spring cage connections for protector bases.
Procedures for mounting the protector base onto various surfaces and boxes, including considerations.
Steps for mounting the protector onto the base, aligning marks, and engaging its locking mechanism.
Procedures for mounting retrofit protectors and labeling protector bases with location tags.
Introduction to using the AutroSafe Configuration Tool for protector setup.
Settings for detector defaults, LED behavior, and sound/pulse patterns within the system.
Process for adding AutroGuard protectors and other units to the AutroSafe system.
Setting default properties and configuring individual protector settings like alarm devices and sensitivity.
Selecting default operation class, sensitivity, and heat response categories for each protector type.
Configuring fire alarm devices, test modes, sensitivity, operation classes, VAD, and sounder levels.
Utilizing the SelfVerify 2.0 function for automatic testing and performing visual inspections.
Procedures for manual testing and recommended test equipment, including automatic test mode.
Guidelines for cleaning protectors and performing hot-swap replacements with new units.
Accessories for locking protectors and diagnosing loop issues with WAS/AS2000.
Components for mounting protectors in air ducts and using conduit boxes for cable management.
Recommended test gases and tools like Testfire/Solo 365 for functional testing.
To Next Page
