EasyManuals Logo

Autronica AutroGuard V-430 User Manual

Autronica AutroGuard V-430
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #95 background imageLoading...
Page #95 background image
Accessories
Technical Handbook, AutroGuard Multicriteria Protector Series V-430, V-530, V-100, V110 and V-120,
AutroGuard-Technical-Handbook, Doc-1004339, Revision 1, 2020-06-29,
Autronica Fire and Security
Page 89
12.8 Telescope Removal Tool
The removal tool for AutroSafe protectors is used together with the
1,26m to 4,5m telescope pole.
Note that In order to use the removal tool, the protector cannot be
locked to the base. Make sure that the protector is unlocked before
attempting to remove it.
12.9 Ground Device
If the loop cable has a screen, a twist wire connector is required in
order to connect the in/out screens together in the protector base.
The screen must be connected to earth in one end only. This will
normally be at the panel.
12.10 Test Gas
If the use of test gas is required according to local regulations,
Autronica Fire and Security recommends the use of smoke test
aerosol Solo A10, 150 ml, part number 116-WBJ-5/07.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Autronica AutroGuard V-430 and is the answer not in the manual?

Autronica AutroGuard V-430 Specifications

General IconGeneral
BrandAutronica
ModelAutroGuard V-430
CategorySecurity Sensors
LanguageEnglish

Related product manuals