Configuration
Technical Handbook, AutroGuard Multicriteria Protector Series V-430, V-530, V-100, V110 and V-120,
AutroGuard-Technical-Handbook, Doc-1004339, Revision 1, 2020-06-29,
Autronica Fire and Security
Page 65
10. Configuration
10.1 Introduction
This chapter provides information specifically intended for the
configuration of the AutroGuardĀ® Multicriteria Protector only.
The following configuration chapters contain references (where
necessary) to the chapters in this handbook where the functionality is
described in detail.
For further information on system configuration, refer to the relevant
configuration handbooks for AutroSafe and Autroprime.
System configuration must be done by trained/certified technical
personnel who are familiar with the system and national/local
regulations.
Note that one protector occupies one address only, regardless of the
number of add-ons (sounder, visual alarm devices, etc.).
10.2 Configuration - AutroSafe
The configuration requires the use of AutroSafe Configuration Tool,
version 4.10 or higher.
To Next Page
Loading...
