In the Event of a Fire Warning
Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. E, 021105,
Autronica Fire and Security AS
Page 42
Step Actions to be taken Display Indication Audible Indication
9
To accept the
Prealarm, press Action
Digit 4 (ACCEPT FIRE
WARNING).
Comments:
In this example, only 1 zone is in Prealarm state. If there are several fire
warnings, each one can be accepted in turn. Fire warnings that are
accepted, will no longer blink in the display. This allows you to see on the
screen whether a detection zone in Fire Warning state is accepted or not.
When the situation is under control (smoke is exhausted, new glass replaced
in the manual call-points, etc.), the system should be returned to normal
operating mode.
10
Press the green Reset
button.
Comments:
The panel enters its idle state.
ACCEPT DZ
19:23
ACCEPT DZ
19:23
PREALARMS
2 CANTEEN
FIRE WARNINGS
19:23
Total: 1
PREALARMS
2 CANTEEN
FIRE WARNINGS
19:23
Total: 1
RESET
Info : Completed
19:23
RESET
Info : Completed
19:23
AUTROSAFE
SelfVerify
AUTROSAFE
SelfVerify
To Next Page
Loading...
Need help?
General
