Service Commands
Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. E, 021105,
Autronica Fire and Security AS
Page 84
14. Service Commands
14.1 Introduction
From the operator panel you can perform service commands. To use
the Service Commands, access level 3 is required.
Access Level Access Remedy Description
3 Password restricted. Accessible by persons trained and authorized to do
reconfiguration of site specific data and maintenance
according to the manufacturer’s published instruction.
4 Mechanical tool. Accessible by persons doing repair work and changing
firmware.
14.2 Service Menu
The Service Menu includes the following submenus:
Service
Test
Log
Loop Commands
Oil & Gas Inhibit
Figure 14-1: Service Menu
To Next Page
Loading...
