Autronica BS-310 - Testing Detection Zones

Service Commands
Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. E, 021105,
Autronica Fire and Security AS
Page 86
14.3.1 Testing Detection Zones
14.3.1.1 Indications on the Operator Panel
During testing, the Testing indicator on the Operator Panel will show a
yellow steady light. The panel’s display will always indicate that a test
is being performed (as shown in the example below). The zones in test
mode are also shown.
TEST
19:23
Total: 1
Total: 1
1 OFFICES
19:23
1:SHOW POINTS
Figure 14-2: Test - indications on the display
www.ukpanels.com