Select O/P GPC 1 press “Enter” chose one mR type (Multi Re-direct), press
“Enter”. Move to the right with “Right Arrow” key to “Invert & Select”, press “Enter”
and select the desired outputs (you chose more than one here) with “Space Bar”,
press “Enter”. You can also select the fervency like the example above.
Inverting an output;
When inverting an output it actually inverts the function, if using an output table as below;
If output is inverted (press “i” when selecting output) and table look like above the output
result would be like this;
Tip:-
If using a Push-Pull output (Stepper & Ignition O/P) and invert you can use it for
supplying power (instead of ground, as most outputs) to a Shift-light, Error light,
Fan relay or others that needs power (+12 volt) instead of ground.
As said earlier the Push-Pull type switch between +12 volt and ground, when
inhibited or not enabled the output are potential free.
When you invert a Push-Pull output it is actually like shifting output polarity, If you
connect one Push-Pull output to a stock fan relay and fan stops instead of starting
you just needs to invert the output.
I/P Analogs
Setup and liniearizes analog I/Ps
To Next Page
Loading...