Avaya 1230 - Connecting the Handset; Connecting the Headset (Optional); Connecting AC Power (Optional)

Using your Avaya 1230 IP Deskphone
48
In position 1, the IP Deskphone sits at a 25-degree angle.
In position 2, the IP Deskphone sits at a 55-degree angle.
Figure 8 on page 47 shows the slots on the back of the
IP Deskphone.
2. Press the foot stand into the slots until it snaps into place.
Note: If you mount your IP Deskphone on a wall, do not attach the
foot stand.
Connecting the handset
Use the following procedure to connect the handset to your IP
Deskphone:
1. Plug the end of the handset cord with the short straight section into
the handset.
2. Plug the other end of the handset cord with the long straight section
into the handset jack marked with the handset symbol as shown
Figure 8 on page 47.
3. (Optional) Thread the cord through the channel in the foot stand (if
installed) so that it exits on the side of the foot stand.
Connecting the headset (optional)
If you have a headset, you can connect the headset to the IP Deskphone
as given in the following procedure:
1. Plug the headset cord into the headset jack on the back of the IP
Deskphone as shown in Figure 8 on page 47.
2. Thread the cord through the channel in the side of the foot stand (if
installed).
3. Set up the headset according to the headset instructions.
Connecting AC power (optional)
Your 1230 IP Deskphone supports AC power or Power over Ethernet
(PoE).