Using your Avaya 1230 IP Deskphone
50
Note: When your LAN cable gets unplugged on an active IP
Deskphone, your IP Deskphone LCD displays an alert message “LAN
cable unplugged”.
Connecting the PC Ethernet cable
Connect a CAT5e PC Ethernet cable between your IP Deskphone and
your computer to enable your computer to access the LAN.
1. Plug one end of the PC Ethernet cable (not supplied) into the PC
Ethernet port on the back of your IP Deskphone as shown in Figure 8
on page 47.
2. Thread the cable through the channel in the foot stand (if installed).
3. Connect the other end of the cable to the LAN port on your PC.
Wall mounting (optional)
You can mount your IP Deskphone on a wall. Wall-mount the IP
Deskphone using the two keyholes on the back of the it. You do not need
the foot stand for wall-mounted applications.
1. Remove the foot stand, if already attached.
2. Ensure all cables are properly routed and the IP Deskphone is
functioning.
3. Make small marks on the wall where you want to align each keyhole
slot.
4. Insert the screws (not provided) so that they protrude slightly from the
wall.
5. Align the keyholes on the back of the IP Deskphone with the screws
in the wall.
6. Slide the IP Deskphone onto the screws to secure it in position.
Entering text
You use can use combinations of the letters and numbers on the dialpad
of your IP Deskphone to, for example, spell names or words in Instant
To Next Page
Loading...
