Avaya 1600 Series - Assembling the 1600 Series IP Telephone; Powering the 1600 Series IP Telephone

1600 Series IP Telephone Installation
12 1600 Series IP Telephone Installation and Maintenance Guide
Note:
Note: For sites using headsets, the 1608 IP Telephone and the 1616 IP Telephone
support only the HIS headset cords. The 1603 IP Telephone does not support
headsets.
Assembling the 1600 Series IP Telephone
!
CAUTION:
CAUTION: Be careful to use the correct jack when plugging in the telephone. The jacks are
located on the back of the telephone housing and are flanked by icons to
represent their correct use.
Powering the 1600 Series IP Telephone
All 1600 Series IP Telephones can be locally powered with a Telephone Power Module (DC
power jack), available separately. In addition, the telephones support IEEE 802.3af-standard
LAN-based power. Before installing a 1600 Series IP Telephone, verify with the LAN
administrator whether the LAN supports IEEE 802.3af, and if so, whether the telephone should
be powered locally or by means of the LAN.
Note:
Note: The last step in assembling the 1600 Series IP Telephone must be applying
power. Apply power either by plugging the power cord into the power source
(local powering) or plugging the modular line cord into the Ethernet wall jack
(IEEE powering).
!
CAUTION:
CAUTION: Failure to connect the proper cables with the proper jacks might result in an
outage in part of your network.
14. Verify that the 1600 Series IP Telephone package includes the following
components:
● 1 telephone set with pre-attached stand.
● 1 handset capable of transmitting and receiving 7KHz audio.
● 1 H4DU 9-foot long (when extended) 4-conductor coiled handset cord,
plugged into the telephone and the handset.
● 1 Category 5 modular line cord for the connection from the IP telephone to
the Ethernet wall jack.
● 1600 Series IP Telephone Safety Instructions.
● 1600 Series IP Telephone Stand Instructions.
● 1600 Series IP Telephone Wall Mount Instructions.