Restart Scenarios
72 1600 Series IP Telephone Installation and Maintenance Guide
6. While the upgrade script file is being downloaded from the HTTP server, all IP telephones
display the following message:
where n is the number of the IP address obtained from the HTTP server, sc is the status
code of the HTTP response and etag is the value of the ETag header.
7. The script file is processed. The software determines that the name of the boot code file in
the telephone (BOOTNAME) is not the latest version. APPNAME is set to the name of an
application file to replace the boot code. The following message displays while the
application file is downloaded into RAM:
where n is the number of KBs downloaded.
8. The following message displays while the application file is stored in flash memory:
where n is the percentage of the file that was stored, and x is the number of elapsed
seconds. This usually takes longer than the file’s download.
9. The telephone is reset so the new system-specific application file can be executed.
10. Continue with the next procedure.
Latest Boot File and System-Specific
Application File Already Loaded
This happens with normal resets.
1. The telephone displays:
2. The telephone detects and displays the speed of the Ethernet interface in Mbps, that is, 0,
10, or 100. The message No Ethernet displays until the software determines whether the
interface is 10 Mbps or 100 Mbps.
Note: The Ethernet speed indicated is the LAN interface speed for both the telephone
and any attached PC.
HTTP:n sc etag
app_filename
n KB received
Saving to flash
n%, x secs
Restarting...
To Next Page
Loading...
