Avaya 1600 Series - Entering Data for Administrative Options; About Local Administrative Procedures

Local Administrative Options
24 1600 Series IP Telephone Installation and Maintenance Guide
Entering Data for Administrative Options
This section applies to all 1600 Series IP Telephones and describes how to enter data for
administrative options.
1. Invoke all local procedures by pressing the Mute button, up to 7 numeric dial pad buttons,
and the # button.
A 6-second timeout is in effect between button presses after pressing the Mute button. If
you do not press a valid button within 6 seconds of pressing the previous button, the
collected digits are discarded. In this case, no administrative option is invoked.
2. Attempts to enter invalid data are rejected, and the telephone emits an error beep.
3. If you enter a numeric digit for a value or for an IP address or subnet mask field after
entering only a zero, the new digit replaces the zero.
4. Press the # button to go to the next step.
5. To backspace, press the leftmost softkey. When you press the applicable button or key to
backspace, the most recently entered digit or period is erased from the display. The cursor
remains in the erased character’s former position.
6. If PROCPSWD is administered as indicated in Chapter 7 of the 1600 Series IP Telephones
Administrator Guide, you must type the Local Procedure password after pressing Mute
and before pressing the code for your given local programming option.
Note:
Note: If PROCSTAT has been administered to 1, you will not be able to invoke any
administrative options other than V I E W.
About Local Administrative Procedures
Local administrative procedures allow you to customize the 1600 Series IP Telephone
installation for your specific operating environment. This section provides a description of each
local administrative option covered in this guide, with references to the pages on which the
option appears.
Note:
Note: Unless otherwise prohibited by administration, the user can view but not change
most of the parameters associated with Local Administrative procedures. For
more information about this option, see the applicable user guides.