Avaya 1600 Series - QoS; IEEE 802.1 P and 802.1 Q

About Local Administrative Procedures
Issue 1 April 2007 25
Note:
Note: Unless otherwise prohibited using administration, the user can view but not
change most of the parameters associated with Local Administrative Procedures.
For more information about this option, see the applicable user guide(s).
Local Programming Option Code See
Set 802.1X operational mode 8 0 2 1 X (8 0 2 1 9) Set the 802.1X Operational
Mode on page 26.
Static addressing A D D R (2 3 3 7) Static Addressing Installation on
page 27.
Automatic Gain Control A G C (2 4 2) Disable/Enable Automatic Gain
Control on page 30.
DHCP chaddr field value C H A D D R (2 4 2 3 3 7) Manually Setting the DHCP
Client Hardware Address on
page 32.
Clear values to factory defaults C L E A R (2 5 3 2 7) Clear Procedure
on page 33.
Enable/disable Debug Mode D E B U G (3 3 2 8 4) Disable/Enable Debug Mode on
page 34.
Group Identifier G R O U P (4 7 6 8 7) Group Identifier
on page 35.
Interface Control I N T (4 6 8) Interface Control on page 36.
Event Logging L O G (5 6 4) Disable/Enable Event
Logging on page 38.
System-specific Logoff L O G O F F (5 6 4 6 3 3) Logoff on page 39.
View Multi-Language Strings M L S (6 5 7) View Multi-Language Strings
on
page 40.
Reset the telephone R E S E T (7 3 7 3 8) Reset System Values on
page 41.
Restart the telephone R E S E T (7 3 7 3 8) Restart the Telephone
on
page 42.
Signaling protocol identifier
(not applicable to Release 1.0)
S I G (7 4 4) Signaling Protocol Identifier on
page 43.
Site-Specific Option number S S O N (7 7 6 6) Site-Specific Option Number
Setting on page 44.
Test the telephone T E S T (8 3 7 8) Self-Test Procedure on page 45.
View current parameter values
and file names
V I E W (8 4 3 9) The View Administrative
Option on page 54.