The View Administrative Option
Issue 1 April 2007 55
2. Press the * button at any time during viewing to display the next name and system value
pair or filename from Table 1
. The first pair returns after the last pair displays. Values that
cannot display on one line wrap to the next line.
Press the # button at any time during viewing to terminate the procedure and restore the
user interface to its previous state. The names and values display in the following order:
Table 1: Parameter Values
Name System Value Format
Model 16ccDccc Up to 8 ASCII characters: MODEL
value.
Phone SN cccccccccccccccccc Telephone Serial Number, up to 18
ASCII characters.
PWB SN cccccccccccccccccc Printed Wiring Board (circuit board)
Serial Number, up to 18 ASCII
characters. Applies only to 16xx IP
Telephones that have a
software-readable PWB serial number
and comcode.
PWB comcode nnnnnnnnn 9 ASCII numeric characters. Applies
only to 16xx IP Telephones that have a
software-readable PWB serial number
and comcode.
PWB version ccccccccc 9 ASCII numeric characters. Applies to
16xx IP Telephones without a
software-readable PWB serial number
and comcode.
MAC address hh:hh:hh:hh:hh:hh Each octet of the MAC address displays
as a pair of hexadecimal numbers.
L2 tagging ccccccccc Up to 9 ASCII characters:
“on” if NVL2Q = 1
“off” if NVL2Q = 2
“auto: on” if NVL2Q = 0 and 802.1Q
tagging is on
“auto: off” if NVL2Q = 0 and 802.1Q
tagging is off
VLAN ID cccc Up to 4 ASCII characters. Value is
L2QVLAN if 802.1Q tagging is on or
“none” of 802.1Q tagging is off.
IP address nnn.nnn.nnn.nnn Up to 15 ASCII characters:
IPADD value.
Subnet mask nnn.nnn.nnn.nnn Up to 15 ASCII characters:
NETMASK value.
1 of 2
To Next Page
Loading...
