Note: Some telephones have restrictions on where calls can be forwarded (see your system manager).
3. Hang up.
Note: You may hear a ring-ping tone from your telephone as each call is forwarded.
To cancel Call Forwarding:
1. Press the Call Fwd button again (while on-hook).
or, Dial the Call Forward Cancel code #2 (while off-hook).
Send All Calls
To send all calls (except priority calls) and automatic callbacks immediately to coverage:
1. Press the Send Calls button (while on-hook).
or, Dial the Send All Calls code *3 (while off-hook)
o Listen for confirmation tone.
Note: You hear confirmation tone only when you use a feature access code.
To cancel Send All Calls:
1. Press the Send Calls button again (while on-hook).
or, Dial the Send All Calls Cancel code #3 (while off-hook).
2. Listen for confirmation tone.
Directory
To search the directory for a name:
1. Press the Directory button (if administered).
2. Key in the selected name with dial pad keys: last name, comma (use * ), first name or initial.
3. Press the Next button for each successive directory name you wish to see. (The Next button must be administered by
your system manager.)
4. To search for a new name, press the Directory button and go through the above sequence again.
5. When you are ready to exit the directory, press
.
To place a call to the name shown on the display:
1. Pick up the handset.
2. While the name is shown, press the Call Disp button (if administered) or, if you do not have a Call Disp button on
your set, press
and then dial the number using the dial pad.
Note: You can also leave your handset on-hook. The speakerphone will turn on automatically when you press Call
Disp if this system feature is enabled.
Call Log
The Call Log Screens
Your telephone can store up to 48 entries in the Call Log. By default, all types of calls are logged, and the number of new
unanswered calls is displayed below the date and time on your telephone.
Note: When power to the telephone is interrupted, all entries in the Call Log are erased.
You can disable the Call Log or specify certain call types you want logged using the Log Setup option on the Options screen.
Two screens allow you to view Call Log information:
• The Call Log Summary screen
• The Call Detail screen
The Call Log Summary Screen
The Call Log Summary screen, which is accessed by pressing the Log softkey on the Home screen, displays the following call
identification information:
• For incoming calls—calling party name and telephone number (if this information is available from the call processing
system). Note that the caller’s name may be abbreviated if it is longer than 16 characters.
2410 Digital Telephone End User Guide | 11 | Page
To Next Page
Loading...
